Sharp ER-A450 Job-Code-Based Programming, Setting the date and time, Setting the date PGM 2

“Direct

Job-Code-Based Programming

This section illustrates how to program items using job codes. Using job codes allows you to program a wide variety of items in comparison with direct programming.

Start this programming by entering a corresponding job code as shown below.

2110 . Å

All the items which can be programmed by the job-code-based programming are listed on this page and the following, and those which can also be programmed by the direct programming are marked with the symbol

” that follows job codes.

Note

When setting the parameters for a job code, the digit that is blinking is the one that can be changed. To go to the position of the parameter that you want to change, press either of the following keys :

.Moves the blinker to the right. ¼ Moves the blinker to the left.

1Setting the date and time

Setting the date PGM 2 2610

Direct

Enter day (one or two digits), month (two digits), and year (two digits) in this sequence.

Procedure

2610 . Å Date (five or six digits) ;

Example Key operation Print

2610 . Å

260898 ;

Setting the time PGM 2 2611 Direct

Date

Set the time using the 24-hour format. For example, when the time is set to 2:30 AM, enter 230; and when it is set to 2:30 PM, enter 1430.

Procedure

2611 . Å Time (max. four digits) ;

27