Sharp UX-A255 Selecting a long or short call, Changing the Short Time and Long Time settings

Setting Up and Using OpenLCR

Note: The following settings are not required as of the printing of this manual. OpenLCR will inform you through its Web site (www.OpenLCR.com) if the settings become necessary in the future.

Selecting a long or short call

Before you make a long distance or international phone/fax call, select whether the call will be a long call or a short call.

♦Your fax needs to know whether the call will be long or short to route it for the best rate.

2. Setting Up OpenLCR

1 Press OpenLCR , FUNCTION .

•Note: If the display shows TABLE NOT EXIST, you must first download the rate data.

Display:

LCR TABLE SELECT

2 Press 1 to select the SHORT TIME setting, or 2 to select the LONG TIME setting.

•The initial SHORT TIME setting is 2 minutes, and the initial LONG TIME setting is 4 minutes. If desired, you can change these settings as explained on the following page.

•The short/long time selection will remain in effect for all calls until you change it.

Changing the SHORT TIME and LONG TIME settings

The initial SHORT TIME setting is 2 minutes, and the initial LONG TIME setting is 4 minutes. If the typical durations of your short and long calls are different, you should change the time settings to ensure that OpenLCR routes your calls for the best rate.

♦For example, if your fax transmissions normally last about 3 minutes and your phone calls last about 5 minutes, set 03 for the SHORT TIME and 05 for the LONG TIME. Before sending a fax, select the SHORT TIME setting (03MIN) in the procedure on the preceding page. Before making a phone call, select the LONG TIME setting (05MIN).

31