Sharp UX-B30 manual Phone goes dead

all.book Page 62 Tuesday, June 1, 2004 4:24 PM

Auto-Cordless Fax Control (answering with an extension phone in TEL mode)

Auto-Cordless Fax Control

(answering with an extension phone in TEL mode)

Important: If a document is loaded in the machine’s feeder, remove it before performing the steps below. (Fax reception is not possible when a document is in the feeder.)

You can also start fax reception in TEL mode by answering any extension phone connected to the same line as the fax machine-even a cordless phone.

1 Answer the extension phone when it rings.

2 If you hear a soft fax tone, wait until your fax responds (the extension phone will go dead), then hang up.

Beep

Phone goes dead

3 If the fax doesn't respond, or if the other party first talks to you and then

wants to send a fax, press once and twice on the extension

phone (only on a tone dial phone). This signals the fax to begin reception. Hang up.

•The above step is necessary if you have set the Fax Signal Receive setting to NO.

•Your fax will not accept the signal to begin reception ( ) if a document is loaded in its feeder.

62