all.book Page 15 Tuesday, June 1, 2004 4:24 PM

Connecting the Power Cord

Connecting the Power Cord

Plug the power cord into a 220-230 V, 50 Hz, earthed AC (2-prong) outlet.

Caution!

Make sure you have removed all of the packing tape before plugging in the power cord (see page 11). Plugging in the power cord without doing so may damage the machine.

The power outlet must be installed near the equipment and must be easily accessible.

The machine does not have a power on/off switch, so the power is turned on and off by simply plugging in or unplugging the power cord.

“CHECK CARTRIDGE” normally appears in the display the first time you plug in the machine. This message appears until you install the print cartridge.

Note: If your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for the power and telephone lines. Surge protectors can be purchased at most telephone specialty stores.

1. Installation

15

Page 19
Image 19
Sharp UX-B30 manual Connecting the Power Cord