Transaction Report | Sharp UX-BS60 instruction

Printing Lists

Transaction Report

This report is printed out automatically after an operation is completed to allow you to check the result. Your fax machine is set at the factory to print out the report only when an error occurs.

♦The Transaction report cannot be printed on demand.

Headings in the Transaction Report

SENDER/	The name or fax number of the other machine involved in the
RECEIVER	transaction. If that machine does not have an ID function, the
	communication mode will appear (for example, "G3").
START	The time at which transmission/reception started.
TX/RX TIME	Total time taken for transmission/reception.
PAGES	Number of pages transmitted/received.
NOTE	(One of the following notes will appear under NOTE in the
	report to indicate whether the transaction was successful,
	and if not, the reason for the failure.)
	OK - Transmission/reception was successful.
	P.FAIL - A power failure prevented the transaction.
	JAM - The printing paper or document jammed, preventing
	the transaction.
	BUSY - The fax was not sent because the line was busy.
	COM.E-X- (Where “X” is a number.) A telephone line error
	prevented the transaction. See Line error on page 119.
	CANCEL - The transaction was cancelled because the
	STOP key was pressed, no document was in the feeder, or
	the other machine requested transmission using a function
	which your fax machine does not have. If you were
	attempting to fax, make sure a document is in the feeder. If
	you were receiving, contact the faxing party to see how they
	are trying to send to you.

Printing	Lists
8.

109

Image 111

Sharp UX-BS60 operation manual Headings in the Transaction Report

Contents

UX-BS60 GREEN-AND-YELLOW Earth BLUENeutral BROWNLive Mains Plug Wiring Instructions At 4% coverage Introduction Applicable telephone line Telephone function Important safety information Page Table of Contents Printing Lists 107 Maintenance 111 Look at the Operation Panel Repeat key Arrow keysFunction key Number keys Icons in the display Microphone locationCOPY/HELP key Unpacking Checklist Installation Open the operation panel Open the print compartment cover Points to keep in mind when setting upAttachments Removing the packing tape Connecting the handset Attaching the paper tray Installation Loading Printing Paper Connecting the Power Cord Installing the Print Cartridge Replacement cartridge Sharp UX-C70BPrint cartridge yield at 4% coverage Initial cartridge Press When this has happened, press Holder return to its home position To make the print cartridge Align Cartridge Press once and twice Quality mode using more/less inkPress Memory Press Once Twice High-quality fax print setting fast/slow printing of faxes Connecting the Telephone Line Cord Extension phone optional Press Once Times EnteringYour Name and Fax Number Enter your fax number by pressing the number keys max digits Press once and once Setting the Date and Time Enter the year four digits Example Mode Setting the Reception ModeSetting the reception mode TEL/FAX mode Flash Select Setting for PBX Press Once and 3 timesPress once and 5 times Volume Adjustment Press or to select the desired volume levelSpeaker Ringer End beep off Error beep offPress To turn on the error beep or To turn off the error beep Press To turn on the key tone or Key tone offPress To turn on the end beep or To turn off the end beep SMS Text Messaging RequirementsPrinting the SMS Quick Reference Sheet Sending an SMS message entering the number manually Sending an SMS Message 555 1 222 Sending an SMS message using an auto-dial number Press Memory If a message is cancelled before being sent Receiving SMS Messages Viewing unread messagesViewing messages in the inbox You can press Viewing the Outbox If the inbox is fullPress Your most recently sent Press or to scroll through your sent messages Printing or Deleting all Messages Printing all messagesDeleting all messages To turn off the function, press SMS SettingsSMS Receive function Press To select on Press To exit SMS center numbers Using the Answering Machine Press REC/MEMO once OnceLift the handset Activating the answering machine When finished, replace the handset or pressOperating the Answering Machine To listen to the outgoing message Toll Saver on Toll Saver OFF Number of rings in A.M. mode Toll Saver function Messages will play Listening to received messages Pressed Press REC/MEMO once Once Erasing received messagesRecording memos Recording phone conversations 2-way recording Optional Answering Machine Settings Setting ICM timeFAX mode on A.M. failure OGM only mode Press To select YES switch toFAX mode, or To select no Press To turn on OGM only mode Transfer FunctionProgramming the transfer number Press once Lift the handset Recording the transfer messagePress the number keys to enter the transfer number Once Twice Checking or erasing the transfer message Turning the Transfer function on and offPress to turn on the Transferyour selection, then Function Override Ringing Programming the override code Press Press the number keys to enter a 3-digit override code Overriding the answering machine Once Press Twice Remote OperationsRemote code number Toll Saver Enter your remote code number and then press Retrieving your messagesPress To turn on the Toll Saver Function, or To turn it off Unless you press twice Changing the fax reception mode Other remote operationsComments To turn Transfer on Press Recording a new outgoing messageTurning the Transfer function on or off Changing the transfer telephone number Recording a memo To turn on OGM only mode Press 1 , 1 ,To turn off OGM only mode Press 1 , 2 , Recording a new transfer message Size and weight Sending FaxesTransmittable Documents Other restrictions Loading the Document Removing a document from the feeder Adjusting the Resolution and Contrast Resolution settingsContrast settings Load the documents Changing the default resolution Press To set the default resolutionTo FINE, or To set it to Standard Pick up the handset or press Digital Sending a Fax by Normal Dialling Sending a Fax by Automatic Dialling Storing fax, phone, and SMS numbers for auto diallingUse it To insert a pause, and then enter the fax or voice NEW Number Press for Edit or for Clear Editing and clearing auto-dial numbers Using an auto-dial number Make the desired changes to the nameIf you are sending a fax, load the documents Sending a fax by Direct Keypad Dialling Correct, press Memory Redial Automatic rediallingIf you are sending a fax, press Memory . Dialling begins Error Correction Mode Press To select YES, orSelect no Dial using one of the following methods Using the Speakerphone to Make a Phone Call Batch Page Numbering Load the documents Press OnceDial the receiving machine and send the fax Broadcasting sending a fax to multiple destinations Sending a Fax From Memory When you are ready to begin transmission, press Memory transmissionTo send a fax through memory, load the document, press If the memory becomes full Receiving Faxes Using TEL/FAX Mode Enter a number as follows for the desired duration Using A.M. ModePseudo Ring Duration for Tel/Fax Mode Press once and 4 times Changing the number of rings Using FAX Mode Example 3 rings Press to return to the date and time display Using TEL Mode Answering with the fax’s handset Display shows FAX ReceivingThen replace the handset Putting a call on hold Answering on an extension phone connected to the same line Press To turn on the function, or Optional Reception SettingsFax Signal Receive Changing the number for remote fax activation Enter the desired number any number from 0 to Example Reception Ratio Select 100% When you add paper and pressSubstitute Reception to Memory To select AUTO, or Example Two Copies each Three originals Select any of the following copy settings as neededMaking Copies Load the documents face down. Maximum of 10 sheets When you are ready to begin copying, press Copy Cut-offIf Memory is Full appears High-quality copy setting fast/slow printing of copies Press To set copy cut-off to YESPress To turn on high-quality copy Caller ID Requires Subscription to Service Special FunctionsPress YES to turn on Caller ID To turn off Caller ID, press Display messages How Caller ID operates Call Press when you have finished viewing the listViewing the Caller ID list Fax To delete calls from the Caller ID list Priority CallPress Memory to store or clear the number Blocking voice calls Blocking Reception of Unwanted Faxes Polling Requesting a Fax Transmission PBX operations Making enquiry callsTransferring calls Printing Lists Press Until the desired list appears in the display OncePress Memory to print the list Caller-ID List Setup ListTelephone Number List Message List Headings in the Transaction Report Transaction Report Press a number from To select the condition for printing Transaction Report print condition Maintenance Cleaning the MachineCleaning the scanning glass and rollers Replace the white roller, inserting the right end first If the scanning glass is difficult to clean Cleaning the housing Cleaning the paper feed roller Aligning the print cartridge Improving Print Quality Press Memory Press to return to the date and time display Cleaning the print cartridge nozzles 116 Wiping the print nozzles and contacts About the lithium battery Cleaning the cartridge holder Problem Solution TroubleshootingProblems and Solutions Line error Speakerphone key Dialling and transmission problems Reception and copying problems General problems 123 SMS messaging problems 124 Press Start KEY Messages and Signals 126 Recalling Audible signals Clearing Paper Jams Clearing a jammed documentOpen the operation panel Gently remove the document Clearing jammed printing paper Sending Faxes Quick Reference Guide 131 Index 132 Page Page Remote Operation Card Remote Commands Other Countries outside the EU Sharp Corporation