Sherwood R-965 manual Entering A Setup Code, English

ENGLISH

ENTERING A SETUP CODE

•This remote control can control up to ten different components.

•Before operating audio and video components using the remote control supplied with this receiver, the setup code for each component should be entered.

•For system remote control operation between Sherwood components , “001” was stored previously in the memory of each device such as “AUD 1” and “AUD 2” for this receiver, “CD” for CD player, “TAPE” for tape deck, “TV” for TV and “DVD” for DVD player.

So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.(When entering each setup code for Sherwood CD player and tape deck, do from the below step .)

Turn on the component you want to control.

1

Note:

•If your component has the discrete POWER ON and OFF(STADNBY) buttons, please do not turn on the component manually.

Example) When entering the setup code for this receiver, turn off this receiver.

Press both the MAIN and OSD/MENU

3	seconds.(/ENTER) buttons simultaneously for 3
	STANDBY		POWER ON
			MAIN
	PAGE	MAIN	FAV

VOLCH/

	DECODE
DSP	DSP

RETURN

STEREO

1 2 3

4	5	6	OSD/MENU
7	8	9
		OSD/MENU
DISP	0	ENT	ENT
MI	M2	M3
	RNC-510

•Then the setup menu will be displayed on the LCD screen.

Note:

• If the display of the corresponding mode disappears, start again from the above step or the current mode.

Select the device corresponding to the

5 component you want to control.

Example) When selecting the “AUD 1” for this receiver or amplifier, etc.

STANDBY POWER ON

P-PRO

AUD1 AUD2

CD TV

DVD VCR

TAPE SAT

AUX CABLE

SELECT

Find the setup code for your component

2 referring to “Set-Up Code Table” in the operating manual of this remote control.

Example) The 3 digit setup codes for the Sherwood “Audio” are 001,024, ...(Hint:The correct setup code for this receiver is “001”.)

Select the Pre-PROgramming mode.

4

STANDBY POWER ON

SETUP

P-PRO LEARN

FAV MACRO

PUNCH RECAL

ERASE EDIT

LIGHT CLONE

• Then the Pre-PROgramming menu will be displayed.

Select the device from which the appropriate

6 3 digit setup code table will be selected. Example) If it is the “AUD 1” code table,

select the “AUD 1”.

STANDBYPOWER ON

AUD1		AUD1
AUD1	AUD2	001	SAVE
CD	TV
DVD	VCR
TAPE	SAT		EXIT
AUX	CABLE
TABLE		DOWN	UP

ENTER

21