Sherwood R-965 manual Enter the 3 digit setup code aiming

Enter the 3 digit setup code aiming the

7	remote control at the REMOTE SENSOR
	on the component.
	STANDBY		POWER ON
		AUD 1
		001	SAVE
			EXIT
		DOWN	UP
		ENTER
	PAGE	MAIN	FAV

VOLCH/

	DECODE
DSP	DSP

For "001" : 0 0 1

RETURN

STEREO

1 2 3

4	5	6
7	8	9
		OSD/MENU	For "102" : 1	0	2
MI	M2	M3
DISP	0	ENT
	RNC-510

•Your component will be turned off(or on in case of this receiver, etc.) when the right code is entered.

•Continue to enter the corresponding codes until your component turns off(or on).

To resume the MAIN menu mode, press the

9	MAIN button twice briefly.
	STANDBY		POWER ON
MAIN
	PAGE	MAIN	FAV

VOLCH/

	DECODE
DSP	DSP

RETURN

STEREO

1 2 3

4	5	6
7	8	9
		OSD/MENU
DISP	0	ENT	The selected device
MI	M2	M3
	RNC-510

• Each time the MAIN button is pressed, the previous mode is resumed.

8	Confirm that it is the right code by selecting
	the SAVE.
	STANDBY	POWER ON

AUD 1

001SAVE

EXIT

DOWN UP

ENTER

•The code is saved and the Pre-PROgramming mode is resumed.

•When you do not want to save the code, select the EXIT on the LCD screen or press the MAIN button.

Operate the component using the

10 corresponding function buttons.

•If any of the buttons fails to operate as they should,

start from the step again to enter the next setup code.

Notes:

•If the Manufacturer/Brand for your component is not listed in “Set-Up Code Table” in the operating manual of this remote control, please use the “ 2 Auto Scan Method” on page 13 in the operating manual of this remote control.

•Although each setup code is designed to work with many different modes, certain codes may not work with some models.( Also, certain codes may only operate some of the functions available on a given model.)

ENGLISH

11

Repeat the above steps to for each of your other components.

22