SETTING THE ROOM2 FEED SETUP

R O O M 2 F E E D S E T U P

V O L U M E

MO D E

: Variable

 

 

 

 

R O O M 2

F E E D

:

Off

 

 

T U N E R

 

V I D E O 1

C D

 

V I D E O

2

 

 

A U X

 

V I D E O

3

 

 

P H O N O

 

V I D E O 4

 

 

V I D E O

5

 

 

 

 

V I D E O

6

 

 

R E T U R N : B a c k

, : S e l e c t

To select the desired volume mode. To select the desired ROOM 2 source.

ENGLISH

The ROOM 2 function allows enjoying one source in the main room while playing another in a different room at the same time.

The analog signals from the 8 CH DIRECT inputs and TAPE MONITOR INs cannot be output from the VIDEO 2 / ROOM 2 (audio) OUTs.

When selecting the VOLUME MODE

1

Press the CURSOR UP()/DOWN() buttons to select the VOLUME MODE.

PAGE

MAIN

FAV

VOL

 

 

1 2 3

4 5 6

7 8 9

0

MI M2 M3

Press the CURSOR LEFT()/RIGHT() buttons to select the desired volume mode for the ROOM 2

2 source.

PAGE

MAIN

FAV

VOL

 

 

1 2 3

4 5 6

7 8 9

0

MI M2 M3

RNC-510

Each time these buttons are pressed, the volume mode changes as follows:

Variable : Select this when an power amplifier is connected to the VIDEO 2/ROOM 2(audio) OUTs for ROOM 2 source playback. You can adjust the ROOM 2 volume level with the MASTER VOLUME CONTROL knob of this receiver or the VOLUME UP/DOWN buttons on the remote control.

Fixed : Select this when an integrated amplifier, etc. is connected to the VIDEO 2/ROOM 2(audio) OUTs. You can adjust the ROOM 2 volume level on the connected integrated amplifier, etc.

Notes :

When you assign the power amplifier for the surround back channels to the ROOM 2, the volume mode is automatically set to Variable.

In case that an integrated amplifier, etc. is connected to the VIDEO 2/ROOM 2(audio) OUTs and the volume mode is set to Variable, if the ROOM 2 volume level is adjusted to high level on both this receiver and the connected amplifier, the ROOM 2 speaker and the connected amplifier may be damaged.

Therefore, be sure to set the volume mode to Fixed for safe operation when using amplifier with its own volume control for ROOM2.

When selecting the Fixed mode, first adjust the volume level as desired in the Variable mode and select the Fixed mode. Then the volume level will be fixed to the adjusted level.

66

Page 66
Image 66
Sherwood R-965 manual Setting the ROOM2 Feed Setup, When selecting the Volume Mode