• Bobbin winding |
|
| S |
|
|
| |
(_ For horizontal | spool | pin |
|
For additional | spool | pin |
|
Pull the handwheel out to the right. |
| ||
Draw thread from the spool. |
| ||
Guide the thread around the thread guide. |
| ||
Thread through the hole in the bobbin from the inside to |
| ||
the outside. |
|
|
|
Put the bobbin on the bobbin winder spindle. |
| ||
Push the bobbin to the right. |
| ||
With free end of the thread held in your hand, depress |
| ||
the foot control. Stop the machine when it has made a | f | ||
few turns and cut | the thread close to the hole in the | ||
bobbin. |
|
|
|
Depress the foot control again. When the bobbin is fully wound, it stops automatically. Return the bobbin winder to its original position by moving the spindle to the left and cut the thread as shown.
Push the handwheel in. The machine does not sew until the clutch is engaged.
f
%
J
f
J
.%
J
NOTE:
Position of the bobbin winder stopper is adjustable for the required amount of thread on the bobbin
(example 1/2 full or full etc.).
Use a screwdriver and loosen the screw one turn or less so that you can adjust the position of the bobbin winder stopper.
Do not take out the screw all the way.
J
16
