Configuring the ATM Virtual Circuit

6.When the [Confirmation] page appears, click [Close] to return to the [ATM VC Configuration] page.The new interface should now display in the [ATM VC Configuration] table.

You may need to create a new WAN interface, or modify an existing interface, so that it uses the new VC. See the instructions for Configuring a PPP, EoA, or IPoA interfaces, depending on the type you use to communicate with your ISP.

You can verify that the new settings work by attempting to access the Internet from a LAN computer. Contact your ISP for troubleshooting assistance.

7.When you have verified that the new settings work properly, click the [Admin] tab, and then click [Commit & Reboot] in the task bar.

8.Click [Commit] to save your changes to the permanent memory.

Modifying ATM VCs

Your device may already be preconfigured with the necessary ATM VC properties, or the table may contain placeholder values that you must change before using the device. Contact your ISP to determine your ATM VC values. Follow these instructions to modify a preconfigured VC:

1.From the [ATM VC Configuration] page, click in the [Action(s)] column for the interface you want to modify.

The [ATM VC Interface - Modify] page appears, as shown in Figure 35.

102

Page 102
Image 102
SMC Networks SMC7204BRA manual Modifying ATM VCs