Adding EOA Interfaces

2.Click [Add]. The [EOA Interface – Add] page appears, as shown in Figure 41.

Figure 41. EOA Interface – Add Page

3.Select one of the predefined interface names from the [EOA Interface:] drop down list.

4.From the [Interface Sec Type:] drop-down list, select the level of IP Firewall to be used on this interface, as defined on page 116.

5.In the [Lower Interface:] field, select the lower-level interface name over which this protocol is being configured. If you are using the ADSL Barricade as a bridge only, skip to step 10.

6.If you are using the ADSL Barricade as a router on your LAN, enter the IP address for the interface in the [Conf. IP Address:] field, and enter the network in the [Netmask:]. This address serves as the public IP address for your entire LAN and is usually assigned by your ISP.

119

Page 118
Image 118
SMC Networks SMC7204BRA manual Adding EOA Interfaces, EOA Interface Add