VPN
The VPN section allows you to setup VPN end points on the Gateway. By doing so, an encrypted tunnel will be established between the Gateway and the remote VPN end point.
To access the VPN configuration page, on the Side Navigation bar, click on [VPN] link.
The Gateway supports 3 types of VPN termination:
•IPSec
•PPTP
•L2TP over IPSec
To enable a VPN end point protocol, deselect the appropriate option on the VPN settings page and click [Apply]. By default, all VPN end point options are disabled.
Create an IPSec VPN Tunnel
To enable and configure an IPSec end point, follow the steps below. Ensure that each end point is assigned a different LAN IP Subnet.
1.On the Side Navigation bar, click on the [VPN] link
2.On the VPN settings page, deselect the [Disable IPsec VPN Functions] option
