Switch

Setting

 

 

75 Ω termination

ON (or attach a 75 Ω terminator.)

switch

 

 

 

Input switch

Set according to the type of input

 

signal from this unit.

 

 

3 Press the PLAY button.

This starts the playback operation. When all data is played back, the unit stops playback.

To perform the following operations

Operation

Do this:

 

 

Stop playback.

Press the STOP button.

 

 

Adjust the audio

For digital or analog audio output

playback level.

Set the VARIABLE switch on the front

 

panel to PB and use the REC/PB

 

LEVEL control knob for each channel.

 

 

 

For outputs from the PHONES

 

connector and MONITOR connector

 

Use the PHONES control knob on the

 

front panel (outputs from the PHONES

 

connector on the front panel and the

 

MONITOR connector on the rear panel

 

are adjusted).

 

 

Do search

See “Searching with the search dial” on

playback in shuttle/

page 43.

jog/variable mode.

 

 

 

Fast forward.

See “Searching with the NEXT and

 

PREV buttons” on page 43.

 

 

Set a cue point

Press the SET button with the J (CUE)

 

button held down at a desired position.

 

 

Jump to a cue

See “Cueing Up a Desired Cue Point”

point.

on page 44.

 

 

Jump to the start

See “To Search in Clip Units (Clip

or end point of a

Jump)” on page 46.

clip.

 

 

 

Inhibit the SUPER

Set the CHARA. DISPLAY menu item

connector from

(see page 66) to OFF.

outputting text

 

information (time

 

data, operation

 

mode indications,

 

etc.) to the video

 

monitor.

 

 

 

a) When the SEARCH ENABLE menu item (see page 65) is set to ENABLE.

Recording and Playing Back Simultaneously

This unit allows you to playback while recording, and to start and stop recording during playback. You can also execute recording during search playback (see page 43) and program playback (see page 47).

Note

Program playback may not be seamless during simultaneous recording and playback.

R button

P button

Time counter display

LINE OUT SELECT button and indicators

To play back during recording

This unit is recording if the indicator to the upper left of the REC button is lit.

Press the P button in the PANEL SELECT section, turning it on, and follow the steps in “Playback Procedure” (page 37).

To start and stop recording during playback

Press the R button in the PANEL SELECT section, lighting it, and follow the steps in “Recording Procedure” (page 35) to start recording. Press the STOP button to stop recording.

To set a cue point during simultaneous recording and playback

Press the SET button with the J (CUE) button held down at a desired position..

When the R button is lit: A cue point is set at the current recording position.

When the P button is lit: A cue point is set at the current playback position.

To select output signals during simultaneous recording and playback

With each press of the LINE OUT SELECT button, the indicator light as follows.

R lights > P lights > R and P both light > R lights > P lights

....

Line output signals change as follows, according to the lit indicators.

R lit: Signals being recorded

P lit: Signals being played back

38 Playback