R and P lit at same time: Output signals are selected by the R and P buttons in the PANEL SELECT section. Recording signals are output when the R button is lit, and playback signals are output when the P button is lit.

If the REMOTE I/F menu item (see page 72) is set to 9PIN(DUAL), output signals can also be switched from the device connected to the REMOTE OUT(P) connector.

To switch the time data display

Time data shown in the time counter display and output from the SUPER connector can be either the data contained in recording signals or the data in playback signals. You can select recording or playback data with the R and P buttons in the PANEL SELECT section.

To select recording signal time data: Press the R button.

To select playback signal time data: Press the P button.

R is displayed before the data in the time counter display when recording data is being output, and P is displayed before the data when playback data is being output. However, when the line output is playback data (the P indicator in the LINE OUT SELECT section is lit) and recording data is being displayed in the time counter display (the R button is lit), R* is displayed before the data in the time counter display. P* is displayed before the data in the time counter display when line output is recording data (the R indicator in the LINE OUT SELECT section is lit) and playback data is being displayed in the time counter display (the P button is lit).

To exit simultaneous recording and playback mode

With the R or P button lit in the PANEL SELECT section, press the STOP button to stop recording or playback. Press the R and P buttons so that both buttons go out.

Note

You cannot exit simultaneous recording and playback mode while performing simultaneous recording and playback. Press the STOP button to stop recording or playback. You can then exit the mode by pressing the buttons in the PANEL SELECT section so that the buttons go out.

Setting Points A and B for Repeat Playback

You can conduct repeat playback of certain sections. You can set the repeat playback start point (point A) and end point (point B) by using the current position or inputting time code values.

To repeat seamless playback after setting points A and B, press the PLAY button when the REMOTE indicator is off.

Note

When performing repeat playback using points A and B as the playback start and end points, make sure that the REPEAT TOP and REPEAT END menu items (see page

64)are set to A POINT and B POINT, respectively.

Setting the current position as start point (point A) or end point (point B)

1 Under the REPEAT FUNCTION menu item (see page 64), set REPEAT MODE to ON.

2 While holding down the SET button in the menu/clip control section, press the K button or the k button.

MENU RESET

SET

MENU RESET

SET

CUE

 

CUE

 

IN

OUT

IN

OUT

Set the start point

Set the end point

(point A)

(point B)

The time code of the current playback position is set as point A or point B.

At the same time, “A set” or “B set” appears for 0.5 seconds in the time counter display.

Once set, the point A or point B time code value is held in the non-volatile memory of the unit until changed. It is not lost when the unit is powered off.

Notes

•When setting point A and B, you can only use time code values. Even when COUNTER is selected with the COUNTER SELECT button, you cannot use a CNT value to set point A or B.

•During simultaneous recording and playback, playback side time code values are registered, even if R (recording side) is selected in the PANEL SELECT section.

Therefore, before setting the A and B points, you should select P (playback side) in the PANEL SELECT section.

Inputting time code values for points A and

B

Using the following procedure, you can modify the time code value for point A or B.

Playback 39