Sony MZ-N510 operating instructions Press, If the recording does not start, Notes

To	Press
Record from the end of the	Press END SEARCH, press N while holding down REC •
current contents1)	T MARK1).
Record over partway	Press N or press . or > to find the start point of
through the previous	recording, and then press x to stop.
recording1)	Press N while holding down REC • T MARK.
Pause	Press X2).
	Press X again to resume recording.
Remove the MD	Press x and open the lid.3) (The lid does not open while
	“TOC Edit” flashing in the display.)

1)If “R-Posi” is set to “Fr End”, recording operations will always start from the end of the previously recorded material without pressing the END SEARCH button (page 49).

2)A track mark is added at the point where you press X again to resume recording while pausing; thus the remainder of the track will be counted as a new track.

3)If you open the lid while “R-Posi” is set to “FrHere”, recording will begin from the top of the disc the next time you record. Check the point to start recording on the display.

If the recording does not start

•Make sure the recorder is not locked (pages 12, 17).

•Make sure the MD is not record-protected (pages 18, 55).

•Premastered MDs cannot be recorded over.

Notes

•Do not change the rechargeable battery during operation even if the recorder is connected to AC power adaptor. The operation may stop.

•“Edit” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move the recorder or disconnect the power source while the indication is flashing in the display.

•If the power supply is disrupted (i.e. the battery is removed or becomes exhausted or the AC power adaptor is disconnected) during a recording or editing operation, or while “Edit” appears in the display, it will not be possible to open the lid until power is restored.

•Note the following when recording from a portable CD player:

—Some portable CD players may not be capable of digital out when the AC power adaptor is disconnected. If this is the case, connect the AC power adaptor to the portable CD player and use it on AC power as the power source.

—On some portable CD players, optical output may not be possible when using an anti-skip function (e.g., ESP* or G- PROTECTION). If this is the case, turn off the anti-skip function.

∗Electronic Shock Protection

z

•The recording level is adjusted automatically. To adjust the level manually, see “Adjusting the recording level manually” (page 28).

•You can monitor the sound during recording. Connect the headphones/earphones with remote control to i and adjust the volume by turning towards VOL + or – (pressing VOL + or – on the recorder). This does not affect the recording level.

20