Sony MZ-N510 operating instructions While Editing

Symptom	Cause/Remedy
No sound comes	• The headphones/earphones plug is not firmly connected.
through the	, Plug in the plug of the headphones/earphones firmly to the
headphones/	remote control. Plug in the plug of the remote control firmly to
earphones.	i.
	• The plug is dirty.
	, Clean the plug.
The recorder skips	• The GROUP button has been pressed (	is flashing in the
to several tracks	display).
ahead or behind	, The recorder returns to normal if no operation has made for 5
when you press	seconds.
. or > on
recorder.
The edited tracks	• This occurs due to the MiniDisc system limitation. The
may exhibit sound	fragmentation of data may cause sound dropout while searching
dropout during	because the tracks are played in higher speed than normal
search operations.	playback.
R-channel sound is	• R-channel sound is not output if connecting to a cassette deck or an
not output when	amplifier with a monaural cord.
playing a track	, Make sure to use a stereo connecting cord. However, if the
recorded from a	connected equipment is a monaural specification, R-channel
cassette deck or an
	sound will not be output even if connecting with stereo
amplifier, or when
	connecting cord.
listening a track
with connected
cassette deck or
through an
amplifier.

While Editing

Symptom	Cause/Remedy
The lid does not	• The power sources have been disconnected during recording or
open.	editing, or the battery have been exhausted.
	, Set the power sources again, or replace the exhausted battery
	with new ones.
Editing could not	• The power sources have been disconnected or a power outage
be done.	occurred while editing.
	, Editing result up to that point is not recorded on the disc. Do
	the editing operation again
The tracks that are	• This is due to the MiniDisc system limitations. To erase a track that
checked out from	has been checked out from your computer, check it back in first,
your computer	and then erase it using the SonicStage software.
cannot be erased.

60