Sony MZ-N510 operating instructions Symptom, Cause/Remedy, Recording cannot be

Symptom	Cause/Remedy
Recording cannot be	• Audio sources may not be securely connected.
done correctly.	, Disconnect the audio sources once and connect them again
	(pages 17, 19).
	• There is no digital signal from the portable CD player.
	, When recording digitally from a portable CD player, use the
	AC power adaptor and disable the anti-skip function (such as
	ESP) on the CD player (page 19).
	• The analog recording was made using a connecting cord with an
	attenuator.
	, Use a connecting cord without an attenuator.
	• Recording level is too small to record (when adjusting the
	recording level manually).
	, Pause the recorder and adjust the recording level (page 28).
	• The power sources was disconnected or a power outage occurred
	during recording.
	, The recording result is not recorded on the disc. Make
	recording again.
	• The premastered MD is inserted.
	, Replace to the recordable MD.
	• The remaining recordable time on the disc is 12 seconds or less
	(“FULL” appears).
	, Replace the disc.
Recording stops	• You tried to overwrite a track which is checked out from the
automatically while	computer. (Tracks that are checked out from the computer
recording.	cannot be overwrite. The recording stops automatically.)
	, Check back the checked out track into the computer.
	, Record from the end of the disc.
Stereo sound is heard	• This is normal. During digital recording, the sound will be stereo
in the headphones/	in the headphones/earphones, even though the recorded sound is
earphones while	monaural.
recording in
monaural.
Momentary noise is	• Due to the special digital audio compression technology used in
heard when	LP4 stereo mode, momentary noise may occur on very rare
recording.	occasions with certain sound sources.
	, Record in SP or LP2 mode.
The lid does not open	• The lid does not open until “Edit” disappears in the display.
after recording.

58