Connecting the Net MD to your computer

After the software installation is completed, connect the Net MD to your computer. Refer to the operating instructions of the Net MD as well.

1 Insert a recordable disc into the Net MD.

2 Make the power source and the dedicated USB cable connections with the Net MD and the computer.

AC

To the USB jack/

To the USB

power

dedicated jack

connecting

adaptor

 

terminal

Net MD

 

devices*

Dedicated

 

 

USB cable

To the DC IN

 

jack

Computer

*If a cradle is supplied with your Net MD, connect the dedicated USB cable to the USB cradle and place the Net MD onto the USB cradle.

3 Check the connections.

When the connections have been properly made, “PCppMD”* appears in the display of the Net MD.

*Depending on the device, “Net MD” may be displayed.

Notes

When using the Net MD connected to your computer, it is recommended that you run the recorder from an AC outlet. If you use a battery to run the Net MD, be sure to use a new dry cell or a fully charged rechargeable battery. We do not assure the results should there be a mis-operation, check-out failure, or destruction of audio data caused by insufficient battery power.

When using the Net MD with the cradle, place the cradle on a stable surface so that the dedicated USB cable does not become detached.

75

Page 75
Image 75
Sony MZ-N510 operating instructions Connecting the Net MD to your computer, To the USB jack, Power Dedicated jack