Location and Function of PartsFront

Overview 1 Chapter

1Lens mount securing rubber

2Lens mount cap

3LENS connector

4AUTO W/B BAL switch

5 REC button

6Auto focus ranging sensor

7VF connector

8Lens mount

9FILTER selector

0ZEBRA button

qa ASSIGN switches qs Lens locking lever

qd MENU knob

qf SHUTTER switch

qg AUDIO LEVEL knob

aLens mount securing rubber

After locking the lens in position using the lens locking lever, fit this rubber over the lower of the two projections. This fixes the lens mount, preventing it from coming loose.

bLens mount cap

Remove by pushing up the lens locking lever (see page 13). When no lens is mounted, keep this cap fitted for protection from dust.

cLENS connector (12-pin)

Connect a lens cable if you are using a 2/3-inch lens or a cable-type 1/2-inch lens. This connector is not used for a 1/2-inch lens which is connected by a hot shoe inside the lens mount.

Consult your Sony dealer when you are using a lens other than VCL-719BXS (supplied with the PDW-F335K).

Note

When mounting or removing the lens on this unit, power off this unit first.

dAUTO W/B BAL (automatic white/black balance adjustment) switch

Activates the automatic white/black balance adjustment functions.

WHT: Adjusts the white balance automatically. If the WHITE BAL switch (see page 15) is set to A or B, the white balance setting is stored in the corresponding memory. If the WHITE BAL switch is set to PRST, the automatic white balance adjustment function does not operate.

BLK: Adjusts the black set and black balance automatically.

eREC (recording start) button

Press to start recording. Press it again to stop recording. The effect is the same as that of the REC button on the supplied lens. When the REC SWITCH function is assigned to an ASSIGN switch on the ASSIGNABLE page of the OPERATION menu, you can use the switch as the REC button.

fAuto focus ranging sensor

When an VCL-719BXS (supplied with the PDW-F335K) auto focus lens is mounted, this measures the distance to the subject, and automatically focuses the lens.

This sensor is provided as an auxiliary function for improving the automatic focusing speed. Even if this sensor is blocked, the focusing precision will not be affected.

gVF (viewfinder) connector (20-pin)Connect the supplied viewfinder.

hLens mount (special bayonet mount) Attach the lens.

iFILTER selector

Selects from the four neutral density (ND) filters built into this unit.

Position

ND filter

number

 

1

CLEAR

 

 

2

1/4 ND (attenuates light to approximately 1/4)

3

1/16 ND (attenuates light to approximately 1/16)

4

1/64 ND (attenuates light to approximately 1/64)

12 Location and Function of Parts