Preparations 2 Chapter
Setting the Area of Use and the Frame Frequency
Using the Unit for the First TimeThe area of use and the frame frequency are not factory preset. Before using this unit, you need to set these items. (You cannot use the unit without setting these items.)
3 Turn the MENU knob to display the desired area of use.
Setting | Area of use |
NTSC (J) AREA | NTSC area (Japan) a) |
NTSC AREA | NTSC area (for areas other than |
| Japan) b) |
PAL AREA | PAL area c) |
a)The composite signal output from this unit is an NTSC signal with no Setup. The frame frequency can be selected as any of 60I, 30P, or 23.98P.
b)The composite signal output from this unit is an NTSC signal with Setup (7.5 IRE). The frame frequency can be selected as any of 60I, 30P, or 23.98P.
c)The composite signal output from this unit is a PAL signal. The frame frequency can be selected as either 50I or 25P.
4 Set the POWER switch to OFF, then once again to ON.
The unit is now ready for use.
Proceed to the next operation: setting the frame frequency.
MENU switch
POWER switch
MENU knob
1 Set the POWER switch to the ON position.
The screen for setting the area of use appears in the viewfinder.
FORMAT SETTING
COUNTRY : NOT SELECTED
PLEASE SET COUNTRY
AND TURN OFF ONCE.
2 Press the MENU knob.
The z mark on the left of “NOT SELECTED” changes to a ? mark, and you can now select the area of use.
FORMAT SETTING
COUNTRY :?NOT SELECTED
PLEASE SET COUNTRY
AND TURN OFF ONCE.
1 Hold down the MENU knob, and move the MENU switch to the ON position.
The TOP menu appears.
<TOP MENU>
USER
USER MENU CUSTOMIZE
ALL
OPERATION
PAINT
MAINTENANCE
FILE
DIAGNOSIS
ADVANCED
2 Turn the MENU knob to move the b mark to “OPERATION”, then press the MENU knob.
The CONTENTS page of the OPERATION menu appears.
You can move to another page when a ? mark appears.
?U00 CONTENTS | TOP |
01.FORMAT
02.SPECIAL EFFECTS
03.ASSIGNABLE
04.DISC
05.CLIP TITLE
06.FILE NAMING
07.GAIN SW
08.EZ MODE/TLCS
09.OFFSET WHITE
10.OUTPUT
3 Press the MENU knob, then turn the knob to move the
bmark to “FORMAT”.
4 Press the MENU knob.
32 Setting the Area of Use and the Frame Frequency