Flange focal length adjustment button
IRIS
M |
|
| T |
|
|
| E |
A | T | W | R |
|
2Chapter | Focus ring | Zoom ring |
|
|
| ||
Preparations |
| MACRO | |
|
| ON | OFF |
|
| FOCUS |
|
|
| M | A |
|
|
| PUSH |
|
|
| AF |
|
| ZOOM |
|
|
| SERVO MANU. |
|
|
| ZOOM switch Auto focus indicator |
1 Open the iris, position the supplied flange focal length adjustment chart approximately 3 meters away from the camera, and arrange the lighting to obtain a satisfactory video output.
2 Set the ZOOM switch to SERVO (power zoom mode).
3 Hold down the flange focal length adjustment button for 3 seconds.
The auto focus indicator flashes orange, and the flange focal length adjustment starts.
During adjustment
The auto focus indicator flashes alternately orange and green.
The message “AUTO FB EXECUTING” appears on the viewfinder screen.
If the adjustment completes correctly
The auto focus indicator goes off, and the message on the viewfinder screen changes to “FB: OK”.
If the flange focal length adjustment does not complete correctly
The auto focus indicator lights red.
Check the subject and lighting conditions, and repeat the adjustment.
When using a
Read the instruction manual for the lens in use as well.
1
2 Open the iris, position the supplied flange focal length adjustment chart approximately 3 meters away from the camera, and arrange the lighting to obtain a satisfactory video output.
3 Loosen the fixing screws on the F.f or F.B ring (flange focal length adjustment ring).
4 Use manual or power zoom to set the lens to telephoto.
5 Point the camera at the chart by turning the focus ring and focus on the chart.
6 Set the zoom ring to wide angle.
7 Turn the F.f or F.B ring until the chart is in focus, being careful not to disturb the focus ring.
8 Repeat steps 4 to 7 until the chart stays in focus ring. 9 Tighten the F.f or F.B ring fixing screws.
36 Preparing the Lens