•If the salvage succeeded, the message “COMPLETED.” appears.
•If the salvage failed, the message “INCOMPLETED.” appears. Clips for which recording did not end normally are lost.
To exit without salvaging
Select NO in step 2 to exit without performing salvage processing.
However, the status of the disc does not change. Salvage is still required to recover the clips for which recording did not end normally. The salvage message will appear again when that disc is inserted again, or when the camcorder is powered on again.
Note
If salvage processing is not done, sections which were recorded normally can be played back, but no new recording can be done on the disc.
|
|
|
|
| 3 Chapter | |
| 11 | 12,13 | 1 | 8 2 | and Recording | |
1 Set the POWER switch to ON. |
|
| ||||
2 Set the FILTER selector and the 5600K button | Playback | |||||
appropriately for the lighting conditions. | ||||||
| ||||||
FILTER selector | Examples of shooting |
| ||||
setting | conditions |
|
| |||
1 | (CLEAR) | Indoor shooting |
|
| ||
2 | (1/4 ND) | Cloudy or rainy outdoor shooting, |
| |||
|
| or to reduce the depth of field a) |
| |||
3 | (1/16 ND) | Sunlight |
|
|
| |
4 | (1/64 ND) | To reduce the depth of field in |
| |||
|
| sunlight |
|
|
|
a)The range over which the subject is sharply in focus. Thus, “reducing the depth of field” means that the range is reduced as well, and “increasing the depth of field” means that it is increasing as well.
3 Check the switch settings on the camcorder.
If you do not have enough time to check the settings of the unit, you can turn the EZ
EZ mode
In EZ mode, the settings of this unit are fixed at standard values, and the lens aperture and white balance are adjusted automatically. In this state, it is not possible to change menu or other settings. To change settings, turn EZ mode off. In the factory default configuration, the ASSIGN 1 switch (see page
13)turns EZ mode on and off.
4 Check the settings in the menu.
Basic Procedure for Shooting | 51 |
|
|