To attach a WRR-855

1 Open the cover of the WRR connector.

WRR connector

2 Set the power switch of the WRR-855 to ON, and set MUTING to ON or OFF.

This enables the WRR-855 power to be turned on and off with the camcorder POWER switch.

3 Insert the WRR-855 into the CA-WR855.

Fasten the screws

(supplied with the WRR-855).

1Use a Phillips type screwdriver to tighten the four screws placed in the tuner fitting as illustrated below.

Note

Check that the four screws are firmly tightened.

2Loosen the adjustment screws of the tuner fitting.

3Adjust the tuner fitting position for a BP-GL95/ GL65/L60S/L80S Battery Pack to be attached, and tighten the adjustment screws to fix its position.

4Attach the mount plate supplied with the WRR- 861/862.

BP-GL95/GL65/L60S/L80S

Adjustment

Mount plate (supplied

screws

with WRR-861/862)

Preparations 2 Chapter

4 Engage the V-shaped plate on the back of the CA-WR855 with the V-groove on the battery attachment shoe, and then slide the CA-WR855 down until it connects to the WRR connector.

CA-WR855

5 Set the AUDIO IN switch to WIRELESS (for CH-1/ CH-2) or W (for CH-3/CH-4).

To attach a WRR-861/862 (When using a BP-GL95/GL65/L60S/L80S Battery Pack)

1 Attach a WRR tuner fitting (not supplied, service part number: A-8278-057-B) to the back of the camcorder.

Back of the

 

camcorder

Phillips type screwdriver

 

2 Attach the battery pack.

For details about attaching the battery pack, see “Using a Battery Pack” on page 31.

3 Mount the tuner on the WRR tuner fitting.

WRR-861/862

For details about the WRR tuner fitting (service part number: A-8278-057-B), contact your Sony dealer.

4 Connect the tuner power cord to the DC OUT connector of the camcorder, and the audio output cable to the AUDIO IN CH-1 or CH-2 connector.

5 Set the switches as follows.

Preparing the Audio Input System

43