Preparations 2 Chapter

•Set the AUDIO IN input selection switch to MIC for the channel to which the audio output cable is connected.

•Set the AUDIO IN (CH-1/CH-2/CH-3/CH-4) switch for the channel to which the audio output cable is connected to REAR (for CH-1/CH-2) or R (for CH- 3/CH-4).

Connecting Line Input Audio Equipment

1 Connect an audio mixer or other external audio system component to the AUDIO IN CH-1/CH-2 connector as shown below.

AUDIO IN (CH-1/CH-2) switch:

Set to REAR.

AUDIO IN

FRONT

WIRELESS

REAR

Connecting the Remote Control Unit

Connecting the RM-B150/B750 Remote Control Unit enables remote control of the principal camera and VDR functions.

Connecting the remote control unit to the REMOTE connector (8-pin) automatically puts the camcorder into remote control mode. If you disconnect the remote control unit, the remote control mode is cancelled.

Refer to the RM-B150/B750 Operation Manual for the maximum cable length for connections between the camcorder and the RM-B150/B750.

RM-B150/B750

AUDIO IN CH-1/CH-2 connector

AUDIO IN input selection switch: Set to LINE.

+48V ON

LINE MIC

to audio mixer, etc.

REMOTE connector

Remote control cable

Note

2 Set the AUDIO IN input selection switch to LINE for the channel to which the external audio equipment is connected.

Selection of the recording audio input

Set the AUDIO IN (CH-1/CH-2/CH-3/CH-4) switch for the channel to which the audio device is connected to REAR (for CH-1/CH-2) or R (for CH-3/CH-4).

Before connecting/disconnecting the remote control unit to/from the camcorder, be sure to turn off the camcorder POWER switch.

Camcorder switch functions when the remote control unit is connected

Connecting the remote control unit disables the following switches on the camcorder.

•GAIN switch

•OUTPUT/DCC switch

•WHITE BAL switch

•AUTO W/B BAL switch

•SHUTTER switch

Paint adjustment when the remote control unit is connected

The settings of the paint adjustment that were in effect the last time the remote control unit was used are recalled.

When the monitor is connected to the remote control unit

The MONITOR connector (BNC type) of the RM-B150/ B750 outputs the same signal as that from the VIDEO OUT connector on the camcorder.

44 Connecting the Remote Control Unit