Lower surface of the disc | Write Inhibit tab |
| Slide in the direction |
Write Inhibit tab settings | of the arrow |
| |
SAVE | SAVE |
Recording enabled | Recording disabled |
You can also write protect individual clips. For details, see “Locking
Proceed as follows.
1 Turn on the POWER switch.
POWER switch
HUMID indicator
Note
If there is condensation inside the VDR section, the message “HUMID” appears in the status display on the LCD monitor. If this happens, wait until the indicator goes off before going on to step 2.
2 Press the EJECT button.
This opens the lid of the disc compartment.
EJECT button
Lid of the disc compartment
3 Insert the disc in the V direction, and close the disc compartment lid manually.
Insert the disc.
V indication on the outside
Push and close the lid.
The disc is loaded.
Note
To insert the disc correctly, make sure that the camcorder is in the upright position (the grip upside, the bottom downside).
Unloading a discWith the power supply on, press the EJECT button to open the disc compartment lid and eject the disc, then remove the disc. If you are not going to insert another disc, close the disc compartment lid.
Formatting a DiscUsing a new discAn unused disc requires no formatting operation. The disc is automatically formatted so that it is ready to use when loaded into this unit.
Using a disc on which material is recordedTo format a recorded disc, load the disc into the unit then do as follows.
Note
When a recorded disc is formatted, all the data on the disc is erased. (Locked clips (see page 81) are also erased.)
Playback and Recording 3 Chapter
Handling Discs 49