Overview 1 Chapter
cAUDIO IN
connectors (XLR type,
Connect other audio equipment or external microphone. Set the input selection switches as shown below according to the microphone or equipment.
LINE (left position): For connecting an external audio signal source such as a stereo amplifier
MIC (center position): For connecting any microphone other than 48 V microphone
MIC +48V ON (right position): For connecting a 48 V microphone
Signals input to the AUDIO IN
1)When the AUDIO IN
Note
If MIC +48V ON is selected for a microphone other than 48 V microphone, the microphone may be damaged.
d (i.LINK) DV OUT S400 connector
Connect to a device supporting the DV format or a computer, using an i.LINK cable (DV cable).
Notes
•If video and audio signals are not output from the
external device connected to the (i.LINK) DV OUT S400 connector, disconnect the i.LINK cable (DV cable) and then reconnect it, making sure that it is firmly seated.
•When you connect the camcorder and other equipment, such as a hard disk drive, with an i.LINK interface to a computer with i.LINK connectors, turn off the power of the computer, the other equipment, and the camcorder before connecting them using the i.LINK cable (DV cable). If a
1) Equipment that can be powered through i.LINK cable (DV cable)
eREMOTE connector
Connect an
Note
Before connecting/disconnecting the Remote Control Unit to/from the camcorder, be sure to turn off the camcorder POWER switch.
fDC OUT 12V (DC power output) connector
Supplies power for a
Do not connect any equipment other than the UHF synthesized tuner.
gTC (timecode) connector (BNC type) and IN/OUT selector switch
•IN/OUT selector switch: IN
To apply an external lock to the timecode, input the reference timecode.
•IN/OUT selector switch: OUT
To lock the timecode of an external VTR to the timecode of this unit, connect this connector to the external VTR’s timecode input connector.
hVIDEO OUT (video output) connector (BNC type) Outputs a video signal for a video monitor. When the output signal is composite, setting menus, timecode, or shot data can be superimposed on the camera output video depending on the menu settings, and you can view them on the monitor screen. To lock the timecode of an external device to the timecode of this unit, connect the genlock signal input connector of the external device to this connector.
Notes
•The subcarrier phsase cannot be adjusted.
•Video signals are not output if the connection destinations of these connectors are not terminated properly.
iAUDIO OUT
Output the audio singnals being recorded or played back. Connect to a stereo amplifier or video monitor’s audio input connectors.
24 Location and Function of Parts