Appendix

Appendix

Important Notes on OperationUse and Storage

Do not subject the unit to severe shocks

The internal mechanism may be damaged or the body warped.

Do not cover the unit while operating Putting a cloth, for example, over the unit can cause excessive internal heat build-up.

After use

Always turn off the POWER switch.

Before storing the camcorder for a long period Remove the battery pack.

Shipping

•Remove the disc before transporting the unit.

•If sending the unit by truck, ship, air or other transportation service, pack it in the shipping carton of the unit.

Care of the unit

Remove dust and dirt from the surfaces of the lenses or optical filters using a blower.

If the body of the unit is dirty, clean it with a soft, dry cloth. In extreme cases, use a cloth steeped in a little neutral detergent, then wipe dry. Do not use organic solvents such as alcohol or thinners, as these may cause discoloration or other damage to the finish of the unit.

In the event of operating problems

If you should experience problems with the unit, contact your Sony dealer.

Use and storage locations

Store in a level, ventilated place. Avoid using or storing the unit in the following places.

•In excessive heat or cold (operating temperature range: 0°C to 40°C (32°F to 104°F))

Remember that in summer in warm climates the temperature inside a car with the windows closed can easily exceed 50°C (122°F).

•In damp or dusty locations

•Locations where the unit may be exposed to rain

•Locations subject to violent vibration

•Near strong magnetic fields

•Close to radio or TV transmitters producing strong electromagnetic fields.

•In direct sunlight or close to heaters for extended periods

To prevent electromagnetic interference from portable communications devices

The use of portable telephones and other communications devices near this unit can result in malfunctions and interference with audio and video signals.

It is recommended that the portable communications devices near this unit be powered off.

Note on laser beams

Laser beams may damage the CCDs.

If you shoot a scene that includes a laser beam, be careful not to let the laser beam be directed into the lens of the camera.

Use at a high temperature

If the unit is used at a high temperature, white flecks may appear on the screen.

Fitting the zoom lens

It is important to fit the lens correctly, as otherwise damage may result. Be sure to refer to the section “Mounting the Lens” on page 35.

Viewfinder

•Do not leave the unit with the eyepiece pointing directly at the sun.

The eyepiece lens can concentrate the sun’s rays and melt the interior of the viewfinder.

•Do not use the viewfinder close to strong magnetic fields. This can cause picture distortion.

160 Important Notes on Operation