Parts of Functions and Names 2 Chapter

2-2 Control Panel

1Remote control switch and NETWORK access indicator

2 ACCESS indicator

3 On/standby switch and indicator

4AUDIO MONITOR buttons

SHUTTLEJOG

 

 

 

AUDIO MONITOR

 

 

L

 

 

 

 

 

 

 

 

CH-1 CH-2

CH-3

CH-4

CH-5 CH-6 CH-7

CH-8

R

 

 

 

 

 

 

 

ACCESS

 

 

 

 

 

 

 

NETWORK

SUBCLIP THUMBNAIL

MENU

SET

RESET

SHIFT

 

 

 

 

 

 

 

LOCAL

 

 

 

 

 

 

 

REMOTE

 

 

 

 

 

 

 

 

 

CLIP

ESSENCE SYSTEM

S.SEL

MARK1

 

 

MENU

MARK

MENU

 

 

 

PREV

 

PLAY

NEXT

STOP

 

 

 

 

 

 

 

IN

 

OUT

TOP F REV

F FWD END

 

 

 

 

 

 

 

 

 

 

MARK2

1 Jog/shuttle control block (see page 21)

2 Arrow buttons(see page 21)

3Operating mode selection/menu setting section (see page 22)

4Playback controls (see page 22)

aRemote control switch and NETWORK access

indicator

Different positions of the switch allow different operations as follows.

NETWORK: Enables access to the network. The indicator lights when an external network device is being accessed. In this state, operation from the control panel is not possible.

LOCAL: Enables operation from the control panel.

REMOTE: Enables remote control of the PDW-V1 from a device connected to the S400 (i.LINK) connector on the side panel.

bACCESS indicator

This lights when the disc is accessed and when a file is opened by a FAM or FTP connections (see page 55).

If the on/standby switch is set to the 1 position while this indicator is lit, access to the disc is completed before the unit switches to the standby state.

Note

While the ACCESS indicator is lit, do not turn off the AC power switch, disconnect the power cord, or remove the battery. This could lead to a loss of data from the disc.

cOn/standby ("/1) switch and indicator

When the AC power switch on the rear panel is in the " position, or a battery is loaded, this switches the PDW-V1 between the operating (") and standby (1) states. When the switch is moved to the " position, the indicator lights. When the switch is moved to the 1 position, the indicator goes off.

When operating the PDW-V1 from an AC power supply, normally leave the AC power switch in the " position, and switch the PDW-V1 between the operating and standby states using the on/standby switch.

dAUDIO MONITOR (audio monitor channel selection) buttons

Each of the L (upper) and R (lower) rows has buttons CH- 1 to CH-8 corresponding to channels 1 to 8. When a button is pressed, it lights, and the corresponding audio channel is output from the PHONES jack and speaker on the front panel and AUDIO MONITOR OUT L/R connectors on the side panel.

In each of the L and R rows, if the buttons for more than one channel are selected simultaneously, the selected channels are mixed on the audio monitor output.

20 2-2 Control Panel