Selection Scene 5 Chapter

1 Carry out steps 1 to 4 in the procedure, “Moving a sub clip” above.

2 Use the arrow buttons to select TRIM, and press the SET button.

The first frame of the selected sub clip appears in a full-screen display. In this state, you can carry out playback and search within the clip including the selected sub clip.

To cancel the trim and escape from the sub clip trim screen

Hold down the SHIFT button and press the SET button.

3 Carry out playback and search to find the new location of the IN point or OUT point of the selected sub clip.

4 At the point where you want to set the new IN point or OUT point, hold down the G/IN button (when changing the IN point) or the g/OUT button (when changing the OUT point), and press the SET button.

Depending on which button you pressed, this sets the IN point or OUT point, and the IN indicator or OUT indicator lights.

To change both the IN point and the OUT point, repeat steps 3 and 4.

To reset the IN point or OUT point, hold down the G/IN button or the g/OUT button and press the RESET button.

The IN point and the OUT point return to the state before the sub clip trimming screen was displayed.

To cue up the IN point or OUT point, hold down the the G/IN button or the g/OUT button and prees the PREV or NEXT button.

Note

You can press the THUMBNAIL button to return to full-screen sub clip display, without trimming a sub clip.

5 When the new IN and/or OUT points are set, hold down the SHIFT button and press the SET button.

This carries out the trimming, and the screen returns to the sub clip thumbnail display.

To cancel the trim operation

Reset the IN point and the OUT point to return to the state before the sub clip trimming screen was displayed, then hold down the SHIFT button and press the SET button.

Deleting a sub clip

Proceed as follows.

1 Carry out steps 1 to 4 in the procedure, “Moving a sub clip” (page 48)

2 Use the arrow buttons to select DELETE, and press the SET button.

The sub clip deletion screen appears.

To cancel the deletion, and escape from the sub clip deletion screen

Do either of the following.

•Use the left or right arrow button to select CANCEL, and press the SET button.

•Press the RESET button.

The screen returns to the sub clip thumbnail display.

3 Use the left or right arrow button to select OK, and press the SET button.

50 5-2 Basic Operations