To cancel changing a setting
Before pressing the SET button, press the MENU button.
The menu disappears from the status display, without saving the new setting.
4
SHUTTLEJOG
AUDIO MONITOR
L L
R R
ACCESS
NETWORK LOCAL REMOTE
SUB
CLIP THUMBNAIL MENU SET RESET SHIFT
To change network settings, carry out steps 1 to 3 in the item, “To display a menu item setting” above, to display the NETWORK CONFIG menu item, then carry out the following operations.
For details of the settings, consult your network administrator.
When the IP address is assigned automatically Check that the network cable is connected to this unit before carrying out the operation.
SHUTTLEJOG
AUDIO MONITOR
L L
R R
| CLIP | ESSENCE SYSTEM S.SEL | MARK1 | |
| MENU | MARK | MENU |
|
PREV | PLAY | NEXT | STOP |
|
|
|
| IN | OUT |
TOP F REV | F FWD END |
MARK2
1 2,3 3
1 Using the J/j buttons, display “>IP address.” 2 Press the k button.
The IP address appears, and the digit that can be changed flashes.
ACCESS
NETWORK LOCAL REMOTE
SUB
CLIP THUMBNAIL MENU SET RESET SHIFT
Menus 7 Chapter
| CLIP | ESSENCE SYSTEM S.SEL | MARK1 | |
| MENU | MARK | MENU |
|
PREV | PLAY | NEXT | STOP |
|
|
|
| IN | OUT |
TOP F REV | F FWD END |
MARK2
4 1,3 2
1 Using the J/j buttons, display “>DHCP.”
2 Press the k button.
3 Press the j button, to display “>> ENABLE.”
4 Press the SET button.
To check the assigned IP address
In the NETWORK CONFIG menu, using the J/j buttons, display “>IP address,” then press the k button.
Note
If the IP address cannot be assigned, this is shown as “000.000.000.000.” In this case, consult the network administrator.
To set the IP address
First set DHCP to “DISABLE.” (See the previous item, “When the IP address is assigned automatically.”)
Flashes to indicate that the digit can be changed.
3 Set the IP address.
To select a different digit to be changed
Use the K/k buttons.
To change the value of a digit
Turn the jog dial or shuttle dial.
Turning clockwise increases the value, and turning counterclockwise decreases the value.
The J/j buttons can be used.
To return to the factory default setting
Press the RESET button.
4 When all digits are set, press the SET button.
This returns to the NETWORK CONFIG menu.
To cancel a setting
Before pressing the SET button, press the MENU button.
This returns to the NETWORK CONFIG menu, without saving the new setting.
5 Repeat steps 1 to 4 as required, to set the subnet mask and default gateway.
82