7-4-2 Maintenance Menu Operations
This section describes the indications in the maintenance menu and how to change the settings.
To display a menu item setting
To display the maintenance menu item settings, change the switch setting within the unit, then carry out the following operations.
For information about how to change the switch setting within the unit, see page 76.
DATA | DATA | DATA | DATA | VITC VIUB COUNTER VITC | ALARM |
| |||
|
|
|
|
| |||||
|
|
|
| HOURS | MINUTES | SECONDS | FRAMES | ||
|
|
|
| AUDIO | 625 | IMX[50 40 30 | ] | ||
|
|
|
| 48CH | 16 24 BIT | 525 | DVCAM |
| |
CH- 15 | CH- 26 | CH- 37 | CH- 48 | BATT | E |
|
| F |
|
12
SHUTTLEJOG
AUDIO MONITOR
L L
R R
Flashes to indicate that there is a next level
To return to the item group
Press the K button.
To change the menu item
Use the J/j buttons.
4 Press the k button.
The setting value appears.
To return to the menu item
ACCESS
NETWORK LOCAL REMOTE
SUB
CLIP THUMBNAIL MENU SET RESET SHIFT
Press the K button.
| CLIP | ESSENCE SYSTEM S.SEL | MARK1 | |
| MENU | MARK | MENU |
|
PREV | PLAY | NEXT | STOP |
|
|
|
| IN | OUT |
TOP F REV | F FWD END |
MARK2
2,3 3,4
1 Press the MENU button.
The menu appears in the status display.
2 Hold down the COUNTER button, and press the SET button.
In the status display, first “MAINTE MENU” appears
When there is a
Repeat step 3.
To change the setting of a menu item
To change the setting of the currently displayed menu item, carry out the following operations.
For details of changing settings of
SHUTTLEJOG
AUDIO MONITOR
L L
R R
Menus 7 Chapter
momentarily, and then the item group name appears.
ACCESS
NETWORK LOCAL REMOTE
SUB
CLIP THUMBNAIL MENU SET RESET SHIFT
To change the item group
Use the J/j buttons.
3 Press the k button. The item name appears.
| CLIP | ESSENCE SYSTEM S.SEL | MARK1 | |
| MENU | MARK | MENU |
|
PREV | PLAY | NEXT | STOP |
|
|
|
| IN | OUT |
TOP F REV | F FWD END |
MARK2
2 1
1 Using the J/j buttons, display the desired setting.
2 Press the SET button.
This saves the new setting, and the menu disappears from the status display.