To set the internal switch to on
1
DATA | DATA | DATA | DATA | VITC VIUB COUNTER VITC | ALARM |
| |||
|
|
|
|
| |||||
|
|
|
| HOURS | MINUTES | SECONDS | FRAMES | ||
|
|
|
| AUDIO | 625 | IMX[50 40 30 | ] | ||
|
|
|
| 48CH | 16 24 BIT | 525 | DVCAM |
| |
CH- 15 | CH- 26 | CH- 37 | CH- 48 | BATT | E |
|
| F |
|
12
SHUTTLEJOG
AUDIO MONITOR
L L
R R
ACCESS
NETWORK LOCAL REMOTE
SUB
CLIP THUMBNAIL MENU SET RESET SHIFT
Menus 7 Chapter
2
S1902, switch 4
1 Using a Phillips screwdriver, remove the bottom cover.
There are five screws fixing the cover.
2 Using a sharp implement such as a
3 Replace the bottom cover.
Note
Tighten the screws firmly.
To enable extended menu display in the maintenance menu
Carry out the following operations.
| CLIP | ESSENCE SYSTEM S.SEL | MARK1 | |
| MENU | MARK | MENU |
|
PREV | PLAY | NEXT | STOP |
|
|
|
| IN | OUT |
TOP F REV | F FWD END |
MARK2
8 3,5,7 4,6
1 Press the MENU button.
The menu appears in the status display.
2 Hold down the COUNTER button, and press the SET button.
In the status display, first “MAINTE MENU” appears momentarily, and then the item group name appears.
3 Using the J/j buttons, display “Setup” in the status display.
4
5 Using the J/j buttons, display “> Extended” in the status display.
6 Press the k button.
The status display shows the current setting (“>> DISABLE”).
7 Press the j button, to display “>> ENABLE” in the status display.
76