The password is set to “pdw-v1” when the unit is shipped from the factory.
The login is complete when the password is verified.
See 6-3-1 “Command List” (page 61) for the FTP commands supported by this unit.
If the connection times out
This unit terminates FTP connections if no command is received within 90 seconds of the last command. If this occurs, log out (see the next section) and repeat steps 2 to 4.
Note
If you power this unit off during an FTP connection, the data transferred thus far is discarded.
To log out
To log out after finishing file operations, enter “QUIT” at the command prompt and press the Enter key.
6-3 FTP File Operations
Enter the password and press the Enter key.
5
Enter the user name “admin” and press the Enter key.
When the user name is verified, you are prompted to enter a password.
4
Note
Login is not possible unless a disc is loaded and the unit is in the state described above.
2 Start the command prompt.
3 Enter “ftp <SP> <IP address>,” and press the Enter key. (<SP> refers to a space.)
For example, if the IP address of this unit is set to “192.168.001.010,” enter “ftp 192.168.1.10.”
Refer to the Windows help for more information about the FTP command.
If the connection succeeds, you are prompted to enter a user name.

Operations File 6 Chapter

60