5-3. Connecting to host computer (parallel interface)
Ferrite core
Fig.5-5 Connecting the parallel interface cable
1Turn off power to both the host computer and the printer.
2Insert one terminal of the interface cable into the printer’s connector, as shown in the diagram, and fasten
it there with the clasp.
3Insert the other terminal of interface cable into the host computer’s con- nector, and again fasten it with the clasp.
ENGLISH
5-4. Connecting to a Peripheral Unit
You can connect a peripheral unit to the printer using a modular plug. The following describes how to install the ferrite core and make the actual connection. See “Modular plug” on page 165 for details about the type of modular plug that is required. Note that this printer does not come with a modular plug or wire, so it is up to you to obtain one that suits your needs.
Important!
Make sure that the printer is turned off and unplugged from the AC outlet and that the computer is turned off before making connections.
Ferrite core (20 mm diameter) 1 Affix the smaller ferrite core onto the modular wire as shown in the illustration below.
Connector Cable
Fig.
– 10 –
