7-3-2. Hexadecimal Dump Mode
ON LINE + POWER ON (Turn the power on while holding the ON LINE switch depressed.)
Each of the signals sent from the computer to the printer will be printed out in hexadecimal code.
This function allows you to check if a control code sent to the printer by the program being used is correct or not. The last line is not printed if its data is less than one full line. However, if the ON LINE switch is pressed to set the off line mode, the last line will be printed. To turn off the mode, it is necessary to turn off the printer completely.
ENGLISH
Fig. 7-3 Hexadecimal dump printing sample
7-3-3. Adjusting the Dot Alignment
You may never have to use the procedure described in this section, but after you have been using your printer for some time you may find that the dots of some graphics do not align correctly. For example, what should look like:
may come out looking like one of the following:
or like this
– 24 –
