Star Micronics SP2000 user manual 162

■ DIP switch 1		Factory presetting: All ON*1
SW	Function	ON	OFF
1-1	Not used	(Always ON)
1-2	Hand shaking (BUSY condition)	Receive buffer	Recive
		full or offline	buffer full
1-3	Always ON	Should be set on
1-4	Auto Cutter *1	Invalid	Valid
1-5	Printing width *2	210 dots	200 dots
		(420 half dots)	(400 half dots)
1-6	Automatic status function *3	Invalid	Valid
1-7	Should not be change	(Should be set on)
1-8	Command emulation	Star	ESC/POS

*1.The factory settings for enabling/disabling the auto-cutter are as follows. Models without auto-cutter (SP2300 Series): Invalid (Switch 1-4 = on) Models with auto-cutter (SP2500 Series): Valid (Switch 1-4 = off)

Note: If the auto-cutter is valid on models without this function, a mechanical error will occur. Do not enable.

*2 Total dot number for one line.

(This setting determines the default print range and number of digits as follows.)

Switch 1-5	Print range	ANK default digits (ANK 7 ⋅ 9/5 ⋅ 9)
ON	63 mm	42/35 digits
OFF	60 mm	40/33 digits

*3 Automatic status function: When valid, the status occurrence conditions are as follows.

Star mode: All status occurrences enabled.

ESC/POS mode: Online/offline factors only. (Same conditions as <GS>a2).

APPENDIX

– 162 –