Sub-Zero ICBBI-36UG, ICBBI-30UG manual Clea Ning ST AI Nless Stee L Exterior, Glassw ELL Clean ING

SU B-ZERO	BUILT -I N USE & CARE
CLEA NING
ST AI NLESS	STEE L EXTERIOR	INT ERI OR CLE ANI NG

COND EN SE R CL EANI NG

CLEAN IN G CO MBI NATIO N UNITS

Classic stainless steel finish: To clean the exte- rior of the classic stainless steel finish, use a soft, nonabrasive stainless steel cleaner and apply with a soft 100% lint-free cloth.

Different light types and source locations can result in variations in shading on different com- ponents and areas of large appliances.

To bring out the natural luster, lightly wipe the surface with a water-dampened microfiber cloth followed by a dry polishing chamois. All work should follow the grain direction of the finish. Better results are obtained by keeping the cloth in continuous contact with the stainless steel.

To clean interior surfaces and removable parts, wash with a mild solution of soap and lukewarm water with a little baking soda. Rinse and dry thoroughly. Avoid getting water on lights, Con- trol Center and display panel.

CAUTION

Do not submerge or pour hot water over cold glass shelves.

CAUTION

Do not use vinegar, rubbing alcohol or other alcohol-based cleaners on any interior sur- face.

GLASSW ELL CLEAN ING

To clean the glasswell of Models ICBBI-42SD and ICBBI-48SD, use a mild solution of soap and water with a little baking soda. Wipe up spills after removing the dispenser water grille.

For the stainless steel areas of the glasswell on Models ICBBI-42SD and ICBBI-48SD, you may use the Stainless Steel Exterior cleaning proce- dure.

In all Sub-Zero Built-In models, the condenser is located behind the grille. First, pull out on the bottom edge of the grill and tilt forward. Then using a soft bristle brush, vacuum to remove dust and lint from the condenser. Refer to the illustration below for location of the condenser. NOTE: To avoid bending the condenser fins, be sure to vacuum in the direction of the fins (up and down). Clean the condenser area every three to six months.

CAUTION

Before cleaning the unit, shut the electricity off at the control panel. When you clean the condenser, wear gloves to avoid injury from the sharp condenser fins.

CAUTION

Failure to clean the condenser could result in temperature loss or mechanical failure or damage.

For over-and-under and side-by side models,

it is possible to turn off one section of your com- bination unit for an extended period without dis- rupting the other.

First, turn the unit off. Press and hold the key pad of the section you want to disable. While

holding the key pad, depress the key pad. Then, release both key pads. The disabled section will appear blank in the Control Center display panel. Repeat the process to turn the sec- tion back on. See Electronic Control System, page 7.

Cond ne ser

lDisp	ya
Pan	l e

Location of condenser Control center display panel

13