Sun Microsystems 1290 manual To Connect the Administrative Console

PCI+ 0-5 slots

10/100BASE-T LOM/SC port

LOM Serial A port

Serial B port

SCSI port, 68 pins

Alarms port

NET0 and NET1 ports

FIGURE 1-26System Controller and I/O Assembly Locations

▼To Connect the Administrative Console

Once the initial configuration is complete, you can perform system administration tasks directly or over the network using the 10/100BASE-T LOM Ethernet port.

Note – Communication on the LOM Serial A port is possible but is subject to interruption by the LOM device. Refer to the Netra 1290 Server System Administration Guide, 819-4374.

1.Connect the 10/100BASE-T LOM Ethernet port to the chosen administrative console (local hub, router, or switch)(FIGURE 1-26).

For 10/100BASE-T LOM Ethernet port connector information, see “10/100BASE-T LOM Ethernet Port” on page 58.

2.Set up the chosen administrative console.

Refer to the Netra 1290 Server System Administration Guide, 819-4374.

36 Netra 1290 Server Installation Guide • May 2006