Sun Microsystems 1290 manual LOM Serial a Serial B

8	1	8	1
LOM Serial A			Serial B
FIGURE A-6	RJ-45 Serial Connectors
TABLE A-7RJ-45 Serial Connector Pinout
Pin			Signal
1			RTS
2			DTR
3			TXD
4			Signal Ground
5			Signal Ground
6			RXD
7			DSR
8			CTS

Note – Serial port B is reserved.

TABLE A-8lists the settings needed to use the LOM Serial A connection. The configuration of this port cannot be changed. Be sure to check the manufacturer’s documentation for your specific terminal server. Communication on LOM Serial A is subject to interruption by the LOM device. Refer to the Netra 1290 Server System Administration Guide, 819-4374.

TABLE A-8Default Settings for Connecting to LOM Serial A

Parameter	Setting
Connector	LOM Serial A
Rate	9600 baud
Parity	No
Stop bits	1
Data bits	8

60 Netra 1290 Server Installation Guide • May 2006