Initial network setup (2)

ppWhen you select “Wireless”:

1.Turn the MULTI JOG knob to select “Search AP”, and then press the ENTER button.

(AP: access point)

2.Turn the MULTI JOG knob to select the desired access point, and then press the ENTER button.

3.If you are asked to enter a wireless security pass- word “KEY”, turn the MULTI JOG knob to select characters you want to enter.

See “Entering characters” on the right column.

4.When you have finished entering all the charac- ters of your password, press the ENTER button.

ppThe wireless security password is case-sensitive, so be careful to enter lower and upper case letters as necessary.

ppIf you enter an incorrect password, “Failure” will appear followed by “Network Problem”.

In that case, go back to Step and make settings again.

When the unit has been successfully connected to the access point, “Success” will appear on the display.

ppMake sure that no LAN cable is connected to this unit.

Now the unit starts to connect to the Internet. When the connection is established successfully, the internet radio menu will be displayed. See page 38 to select a station.

ppIf you are unable to connect the unit to the Internet, refer to the Network item of the Troubleshooting section (page 58).

Entering characters1 Turn the MULTI JOG knob to select a character.2 Move the cursor by pressing/button.

Press the . button to go back to the previous character.

ppRepeat steps to to enter next characters.

ppTo change a character, move the cursor to that char- acter’s position and turn the MULTI JOG knob to select the character desired.

3 Press the ENTER button to confirm the selection.

4 When you have finished entering all the char- acters, make sure that the cursor is to the right of the last character you entered, and then press the ENTER button.

Available characters

0123456789 ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz (space)!”#¤%&’()*+,-./:;<=>?@[\]–_`{}¯

36