Network configuration (1)

Searching an access point

If you have moved or modified your Wi-Fi network environ- ment, or if you have a problem connecting to the Internet, perform the initial network setup to establish the Internet connection again.

Follow the menu items as follows:

”Setup Menu” w”Network” w”Wireless” w”Search AP”

ppFollow the procedures described on pages 34-35 to open the menu.

Network standby setting

If you select “On“ for this setting, the unit turns on and starts playback automatically when it detects an AirPlay or DLNA signal.

Follow the menu items as follows:

”Setup Menu” w ”Network” w ”Wireless” w “Wired” w ”Standby (Off )”, and then select “On”.

ppFollow the procedures described on pages 34-35 to open the menu.

Manual Internet setup

You can check and modify detailed settings of the Internet connection.

Follow the menu items as follows:

To check the current network settings

”Setup Menu” w”Information”

To configure Wired LAN settings

Select “Setup Menu” w “Network” w “Wired”, and then change settings of “DHCP” and “Proxy Setting”.

To configure Wireless LAN settings

Select “Setup Menu” w “Network” w “Wireless”, and then change settings of “DHCP”, “SSID”, “Security”, “Key”, and “Proxy Setting”.

ppFollow the procedures described on pages 34-35 to open the menu.

Using iPod Wi-Fi login sharing

Using this function, you can send the Wi-Fi setting on your iPod/iPhone/iPad to this unit. If you have already finished the Wi-Fi setting for this unit, you do not need to follow the steps below.

This function is supported by the iPod/iPhone/iPad with iOS 5.x or later only.

ppThe following explanations refer to an iPod, but they also apply to use with an iPhone or iPad.

1 Connect an iPod to a Wi-Fi network.2 Turn the unit on.

ppDO NOT connect a LAN cable to the unit.

3 Repeatedly press the SOURCE button to select “Internet Radio”.

If the unit cannot be connected to a Wi-Fi network by using the Internet radio or media player function, the message “Network problem” will appear on the unit’s display. Move on to the next step.

4 Repeatedly press the SOURCE button on the unit or the USB/iPod button on the remote control to select USB/iPod as the source.

ENGLISH

Continued on the next page e

37