Tefal RK203E25, RK203E27 TEFAL781-3in1_NC00111822_Miseen page 1 26/04/12 18:28 Page3, Description, Clean the appliance, Before the first use, Unpack the appliance, Lid, Fig.1, Fig.2

TEFAL781-3in1_NC00111822_Mise en page 1 26/04/12 18:28 Page3

Description

1.	Steam basket	13.	Power cord
2.	Graduation for water and rice	14.	Hotplate
3.	Removable non-stick bowl	15.	Sensor
4.	Rice spoon	16.	Control panel
5.	Lid opening button		a. Keep warm indicator light
6.	Lid		b. RICE/STEAM cooking mode
7.	Inner removable lid		c. Mode switch
8.	Measuring cup		d. Cooking indicator light
9.	Micro pressure valve		e. SLOW COOKING mode
10.	Condensation collector		f. Control switch

11.Handle

12.Spoon support

Before the first useUnpack the appliance

•Remove the appliance from the packaging and unpack all the accessories and printed documents.

•Open the lid by pressing the opening button located on the lid – Fig.1.

•Install the spoon support: insert the plastic hook of the support in the hole located on the bottom of the product, and slide it downwards – Fig.2.

Read the instructions and carefully follow the operating method.

Clean the appliance

• Remove the non-stick bowl, the inner removable lid and the micro pressure valve. To remove the inner lid, press the release clip on the right side to release the lid – Fig.3.

• After removing the inner lid, push up the micro-pressure valve through the hole on the underside of the lid with a finger – Fig.4. To separate the upper and lower parts of the micropressure valve, rotate the valve in the unlocking direction by turning the upper triangle until it is aligned with the open padlock symbol then separate – Fig.5 and Fig.6.

• Clean the bowl, the inner removable lid, the micro pressure valve and all the accessories with a sponge and washingup liquid. Wipe the outside of the appliance and the metal parts of the lid with a damp cloth.

• Dry carefully.

• Replace the micro-pressure valve. Align the upper triangle with unlocked padlock of the micropressure valve to close up the two parts, then rotate in locking direction until the upper triangle is aligned with the locked padlock which indicates the two parts are locked, then re-fit the micropressure valve

3

down into the lid – Fig.7. Make sure that the triangle in the