Teledyne 4060 manual 6 Range ID Relay Connections, When the CRC closes, remove the span command

Series 4060 Installation

2. When the CRC closes, remove the span command.

When CRC opens again, the span calibration is done, and the sample is being analyzed.

3.3.2.7RANGE ID RELAYS

There are three dedicated Range ID relay contacts. They are assigned to relays in ascending order—Low range is assigned to Range 1 ID, Medium range is assigned to Range 2 ID, and High range is assigned to Range 3 ID. Table 3-6 lists the pin connections. Contacts are normally open, and they close when 4060 switches to that particular range.

Table 3-6: Range ID Relay Connections

Pin Function

21Range 1 ID Contact

38Range 1 ID Contact

22Range 2 ID Contact

39Range 2 ID Contact

19Range 3 ID Contact

18Range 3 ID Contact

34Not Used

35Not Used

3.3.2.8NETWORK I/O

A serial digital input/output for local network protocol. At this printing, this port is not yet functional. It is to be used in future options to the instrument. Pins 13 (+) and 29 (–).

3.3.2.9PIN OUT TABLE

The following table summarizes all the outputs/inputs available in the 50 pin D-Sub connector on the back panel of the analyzer.

Teledyne Analytical Instruments 35