6CAUTIONSCaution label on the unit
The label in the fusing area of the unit indicates the following:
: Caution, risk of danger
: Caution, hot surface
Cautions on using
Follow the cautions below when using this unit.

Warning:

•The fusing area is hot. Exercise care in this area when removing misfed paper.
•Do not look directly at the light source. Doing so may damage your eyes.
•Do not switch the unit rapidly on and off. After turning the unit off, wait 10 to 15 seconds
before turning it back on.
•Unit power must be turned off before installing any supplies.

Caution:

•Place the unit on a firm, level surface.
•Do not install the unit in a humid or dusty location.
•When the unit is not used for a long time, for example for consecutive holidays, turn the
power switch off and remove the power cord from the outlet.
•When moving the unit, be sure to turn the power switch off and remove the power cord
from the outlet.
•Do not cover the unit with a dust cover, cloth or plastic film while the power is on. Doing
so may prevent heat radiation, damaging the unit.
•Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
•The socket outlet should be installed near the equipment and be easily accessible.
•The power plug should be unplugged from the outlet once a year or more often to clean
the area between its edges.
If dust collects in the power plug area, humidity or the like may cause the insulation to
deteriorate and a fire may well result.
•Do not throw toner or toner cartridge into fire. Toner may scatter and cause a burn.
Important points when selecting an installation site

Do not install your unit in areas that are:

•damp, humid, or very dusty
•exposed to direct sunlight
•poorly ventilated
•subject to extreme temperature or humidity changes, e.g., near an air conditioner or
heater.