Toshiba Item, function, Description, Self-Cleaning, indicator blinks for 5 seconds, Operation flow and applicable data, etc

FILE NO. SVM-10020

Item Operation flow and applicable data, etc. Description

13.Self-Cleaning∙ Self-Cleaning diagram function

Operation display		ON		OFF	OFF
FCU fan		ON		ON	OFF
	rpm is depend on presetting.			(500RPM)
FCU louver		OPEN		OPEN (12.7º)	CLOSE
Timer display		ON or OFF		ON	ON or OFF
	depend on presetting of timer function.				depend on presetting of timer function.
Compressor		ON or OFF		OFF	OFF
	depend on presetting per room temperature.
CDU fan		ON or OFF		OFF	OFF
	depend on presetting per room temperature.
		Cool mode or dry mode	Self-Cleaning mode		Operation time
		operation more than 10 mins.		operate 30 mins.

Turn off by remote controller or	Automatically turn-off.
timer-off function.

How to Set or Cancel Self-Cleaning operation.

(Default setting from factory is ON)

1.Connect jumper lead at J201 of the indoor P.C. board assembly.

2.To cancel Self-Cleaning operation.

Turn the power supply ON

Press the [RESET] button located on the front panel of the indoor unit for more than 3 seconds.

After 3 seconds, the unit beeps three times.

The Self-Cleaning is cancelled.

3. To set Self-Cleaning operation.

Turn the power supply ON

Press the [RESET] button located on the front panel of the indoor unit for more than 3 seconds.

After 3 seconds, the unit beeps three times and the indicator blinks for 5 seconds.

The Self-Cleaning is set.

One J201 is added, it will effect as following.

The operation when press the RESET button for

3 seconds will be changed from Set/Cancel the AUTO-RESTART to Set/Cancel the Self-Cleaning.

AUTO-RESTART function will not activate. In case of AUTO-RESTART is need, disconnect the jumper J201 and set it again after Set/Cancel the Self-Cleaning finished.

Note :

J201 is near the MCU, so so take steps to ensure that it will not be exposed to excessive of heat. Also take care to avoid solder bridging with the surrounding components.

− 41 −