Toshiba RD-XV48DTKF Setting the Clock, Auto Clock Setting, Manual Clock Setting, 36 EN

E3NG0FD_EN.book Page 36 Wednesday, January 30, 2008 10:37 AM

Setting the Clock

Auto Clock Setting

This unit receives time signals from the analogue / DVB channels, and set the clock automatically. Set the channel tuning before setting Auto Clock.

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Clock” using [U \ D], then press [ENTER].

General Setting

Playback

Display

Video

Recording

Clock

Channel

DivX

HDMI

Reset All

3 Select “Auto Clock Setting” using [U \ D], then press [ENTER].

4 Select “ON” using [U \ D], then press [ENTER].

5 Press [SETUP] to exit.

6 Press [B ON\STANDBY] to turn the unit off.

•The Auto clock function is activated.

•This unit will search for the time every time when the power is turned off.

•Leave the unit off for about 10 seconds to give it time to set the clock.

Hint

•If you want to cancel “Auto Clock Setting”, select “OFF” using [U \ D], and then press [ENTER] at step 4.

Note

•The default setting of “Auto Clock Setting” is “ON”.

•The clock may set itself automatically after you connect the antenna cable to the unit and plug in the mains cable. In this case, the current time will appear on the front panel display.

•If there are only analogue channels memorised in this unit:

-The channel assigned to “901” must receive the PDC signal in order to set the clock automatically.

-The unit will correct the current time by receiving PDC broadcasts whenever the power is turned off.

-Between 23:00 and 1:00, the Auto Clock function will not operate even when the power is turned off.

•The clock cannot be set automatically if you are not receiving a channel in your area that carries a time signal. In this case, set the clock manually.

•The unit will also correct the current time automatically at 8:00 and 1:10 if the unit is in standby mode or if you are watching DVB channel.

Manual Clock Setting

1 In stop mode, press [SETUP]. Select “General Setting” using [U \ D], then press [ENTER].

2 Select “Clock” using [U \ D], then press [ENTER].

3 Select “Clock Setting” using [U \ D], then press [ENTER].

Default date will appear.

4 Press [ENTER] again.

Clock Setting

01 / 01 / 2008 (TUE)

0 : 00

5 Enter the date (day / month / year) using [U \ D].

Press [P] to move the cursor to the next field. If you want to go back to the previous field, press [L].

6 Enter the time (hours / minutes) using [U \ D], then press [ENTER].

The clock will start.

•Although seconds are not displayed, they will be counted from zero.

7 Press [SETUP] to exit.

Note

•Your clock setting will be lost if either there is a power failure or the unit is unplugged for more than 30 seconds.

36 EN