Toshiba RD-XV48DTKF owner manual DVC to HDD / DVD Dubbing, 52 EN, To stop dubbing

E3NG0FD_EN.book Page 52 Wednesday, January 30, 2008 10:37 AM

DVC to HDD / DVD Dubbing

Video	VR
HDD DVD-RW	DVD-RW DVD-R

DVD+RW DVD+R

Before recording from DVC, see page 22 for connection instructions. (See page 94 for DVC to VHS Dubbing.)

Preparing for DV dubbing (DVC to HDD):

• Make sure your DVC is in video mode.

Preparing for DV dubbing (DVC to DVD):

•Insert a recordable DVD.

•Make sure your DVC is in video mode.

If you are dubbing to the HDD, press [HDD] first. If you are dubbing to a disc, press [DVD] first.

1 Select “DV” channel using [INPUT SELECT F] or [PROG. G \ H].

DV

AB-1234 0:00:00

2 Press [REC MODE] to select a recording mode. (See page 37.)

3 Press [DISPLAY].

4 With “Control” highlighted, press [ENTER] to display the available devices to control with the remote control of this unit. Select “DVC” using [U \ D], then press [ENTER].

e.g.) DVC to DVD dubbing

	T	1/ 1	C	1/ 1
					-RW	VR	ORG
Control				DVD		DV
DV Audio				Stereo1		AB-1234
Start Rec						0:00:00

DVD SP 2:00

Now you can operate your DVC with the remote control of this unit.

5 Press [PLAY B] to start playing back the DVC, and find where you want to start dubbing.

Press [STOP C] when it comes to the desired start point.

6 Select “Start Rec” using [U \ D], then press [ENTER].

The dubbing will start.

To stop dubbing;

1Select “Control” using [U \ D], then press [ENTER].

2Select “HDD” / “DVD” using [U \ D] (whichever the recording component you are using), then press [ENTER].

3Press [STOP C].

Note

•The tape will rewind a few seconds when you press [ENTER] at step 6 so that the dubbing starts exactly where you press [PAUSE F] instead of [STOP C] at step 5.

•The unit does not send out the output signal to DVC.

•For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.

•Do not connect more than one DVC.

•The unit can only accept DVC. Other DV device such as cable/satellite box or D-VHS VCR cannot be recognised.

•If no video signal is detected from the DVC during DVC to HDD or DVD dubbing, the recording will be paused and “I” will flash on the TV screen. The recording will resume when the unit detects the video signal again.

•When the DVC is in camera mode, refer to “Guide to DV and On-Screen Display” on page 51.

•Date / time and cassette memory data will not be recorded.

•Pictures with a copy-guard signal cannot be recorded.

•A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called “Fire Wire”. It serves as the interface that connects the PC and peripheral device such as “i.Link” (registered trademark of SONY). It enables digital dubbing between DV devices with little degradation.

•You cannot dub from DVC to both HDD and DVD at the same time.

52 EN