Trilogy Touch Technology 9 manual Telos ONE Alignment

Commander Installation Guide

7.2.1TELOS ONE ALIGNMENT

The level adjustment of the Telos ONE hybrid unit is fairly critical. Slight variations can cause the unit to fail to initiate outgoing calls. The usual symptom will be failure to break the dial- tone when pressing keys on the dial-pad of a Trilogy panel. All units supplied via Trilogy are factory tested but this cannot take account of variations in local telephone lines and switchboards. To quickly re-align the levels, use the LED array on the front of the Telos unit.

To adjust the outgoing level:

¾Initiate an outgoing call from a control panel equipped with a dial-pad, such that dialling tone can be heard on the panel loudspeaker.

¾Press and hold a key on the dial pad, so that the DTMF tone is heard.

¾Select the in/out monitor switch on the Telos to “in”.

¾Adjust the multi-turn control labelled “Gain In” so that the 0 level LED is just illuminated. This is the last green LED: the red LED should not be lit.

To adjust the incoming level:

¾Call the Telos hybrid from another telephone line (e.g a mobile phone).and pick up the call.

¾Select the in/out monitor switch on the Telos to “out”.

¾While the line is active, press a key on the other telephone so that the DTMF tone is heard.

¾Adjust the multi-turn control labelled “Gain Out” so that the 0 level LED is just illuminated. This is the last green LED: the red LED should not be lit.

Trilogy recommends that these levels be checked from time to time, to ensure that the Telos hybrids remain correctly aligned.

NOTE: The Telos hybrid has an intelligent dimming circuit built into the unit, therefore we recommend that the port assigned to the telephone hybrid from the PathFinder GUI is set to 0dB dimming. Please refer to the PathFinder User Guide for more information.

Trilogy Communications Limited Issue 9 Page 57 of 81