Commander Installation Guide
Audio I/O – D15 Fixed Socket
Pin | Function | Notes | |
1 | Slave Mic Input | Line level, | |
2 | +15V Out (for slave mic panel) | NOT protected! | |
3 | Clean Mic Out + | Line level, balanced, pair with 11 | |
4 | Ext CUT Input (for slave mic panel) | Parallel function to front panel Cut | |
5 | Chassis Ground | Switch. Ground to activate | |
| |||
6 | No connection |
| |
7 | External Input to LS Amp - | Line level, balanced, pair with 14 | |
8 | Matrix Audio Input to Panel / parallel output - | Line level, balanced, pair with 15 | |
9 | Ext Mic Cut output (to slave panel) | Normally grounded. O/P is open | |
|
| circuit when front panel cut selected. | |
10 | NOT protected | ||
11 | Clean Mic Out - | Line level, balanced, pair with 3 | |
12 | Mic Ground |
| |
13 | Loudspeaker Output | 8 ohm loudspeaker | |
14 | External Input to LS Amp + | Line level, balanced, pair with 7 | |
15 | Matrix Audio Input to Panel / parallel output + | Line level, balanced, pair with 8 |
NB 15V supplies are also used to derive 12V for panel. (Thermally Fused @ 0.7A)
8.5.3500-30 SERIES DIP SWITCH SETTINGS
Within the panel a series of DIP switches determine the correct panel type. These are factory set and are included for reference in section 10.1
A further set of DIP switches is user accessible at the top side of the panel and control the action of the front panel CUT switch. The factory default is shown in the table below.
Cut Switch Action | DIP 1 | DIP 2 | DIP 3 | |
No action | OFF | OFF | OFF | |
Changeover to HSet MIC (default) | ON | OFF | OFF | |
LS cut | OFF | ON | OFF | |
Changeover to HSet MIC and LS cut | ON | ON | OFF | |
MIC cut | OFF | OFF | ON | |
Changeover to HSet MIC and MIC cut | ON | OFF | ON | |
LS cut and MIC cut | OFF | ON | ON | |
Everything | ON | ON | ON |
Page 70 of 81 | Issue 9 | Trilogy Communications Limited |
