get you there. You’ll find information about using your exercise equipment and what makes for efficient training at Tunturi’s website at WWW.TUNTURI.COM.
ASSEMBLY
Before assembling the device, insure all parts are present:
PACKAGE 1/2
1.Running base
2.Power cord
PACKAGE 2/2
3.Handrails
4.Handlebar/meter unit
5.Assembly kit (contents are marked with an * in the spare part list): keep the assembly tools, as you may need them e.g. for adjusting the equipment
The directions left, right, front and back are defined as seen from the exercising position. In case of problems contact your Tunturi dealer. The package includes
a silicate bag for absorbing moisture during storage and transportation. Two people are needed for the installation. Assemble the equipment as follows:
Open both packages and remove all protective styrox foam pieces.
HANDRAILS
Secure the handrail mounting pieces to the lower ends of the handrails, using six hex screws (A) on each mounting piece. Tighten these screws carefully. NOTE! The left handrail and mounting piece are marked with a round red sticker. Secure both handrails to the running base with two hex screws (B) and washers (C) and with one hex screw (D) and a washer (E). Be careful not to
O W N E R ’ S M A N U A L • T 9 0
damage the wire coming out of the left handrail. NOTE! Do not tighten these bolts until the handlebar and meter have been secured.
HANDLEBAR AND METER
Turn the sliders located at the sides of the handlebars downward so that you can attach them with another screw (F) through the lower hole of the handlebar.
NOTE! Attach the screws as loosely as possible. Do not remove the screws on the sliders. Place the handlebar/ meter unit on the handrails so that the sliders fit the handrail grooves. Connect the wire coming out of the left handlebar with the connector in the meter and push the connected wire inside the handlebar. Push the handlebar/meter unit onto the handrail ends and tighten all the hex screws on the sliders.
Be careful not to damage the handgrip pulse wire: make sure that the wire runs along the middle groove in the handrail. Fasten the handrail bolts. Remove the protective film from the display.
Connect the wire coming out of the left handlebar with the connector located under the running base on the left hand side. For easier access, tilt the treadmill slightly on its right side.
SAFETY KEY
The treadmill cannot be used if the key is not properly installed on the meter; if the key is removed from its place, the treadmill will immediately stop. Insert the safety key into the key holder at the left side of the meter. Ensure that the clip of the safety key is properly attached to your clothing; as the cord tightens, make sure the clip does not detach itself from your clothing before the safety key disconnects from the user interface.
EXTENDED HANDRAILS
Extended handrails can be attached to the T90 treadmill as accessory. Extended handrails enable the T90 to be better used for e.g. for rehabilitation training. Contact your local retailer or Tunturi distributor for further information.
GB
3
